BT3™ Frequency Monitoring System 

FAQ | Instructions

NOTE:  The BT3™ Frequency Monitor has been discontinued.
We have provided this page for informational purposes only.
Click  here for details


       The BT3™ frequency monitoring System has a one of a kind sensor that can be used to measure the frequency of any substance or object. When measuring plants, the frequency of the healthier, more nutritionally balanced plant will always have a higher frequency than the less healthy one.
        In working with rock powders for agricultural application, we choose certain combinations based on their frequency readings. We then send samples to a laboratory for a mineral analysis to confirm our findings, and our choices have always turned out to be the best mineral combinations.
       Frequencies of an individual can be measured also. You can determine where an energy block or leak is occurring in the body by reading the frequency levels. Where there is an energy leak the reading will spike. For example, in the case of a back injury, the meter will show an energy spike at the injured vertebra. If a person isn't feeling well, his or her brain energy reading will be lower than it would normally be if well rested and in good health. You can check specific organs by placing the sensor on that area.  If the organ is not functioning properly, the frequency will be significantly lower than the other organs.* You can even tell whether a person is functioning in a right brain or left brain mode. We have used the meter to test foods and supplements. Generally speaking, a higher energy reading indicates that it is a nutritionally beneficial food. Highly processed foods will show very low frequency readings compared to fresh fruits or vegetables, for example.
        The meter's applications are limited only by one's imagination. The best way to use it is in comparison studies, comparing one product with another, or taking before and after measurements. What makes this frequency meter unique is it's extremely sensitive sensor. Because of its high sensitivity, background interference will usually have to be taken into account. It does take some practice and patience at first. It is easier to use if you find a place in your home, laboratory or office that has as little electromagnetic interference as possible, then always use your meter in that area if you can.  The meter may not give you a zero reading to start with; but a room with minimal interference from radios, computers, etc. is better because you can establish a base line to work with.
        This is only a brief description of what beginning users can do with the BT3™ Frequency Monitoring System. Frequencies have harmonics which have significant meaning or application to mathematicians and scientists involved in the study of sacred geometry, and practitioners using color, sound, and aroma therapies.       
* The BT3 Frequency Monitoring System is intended as an instrument for research, and not as a diagnostic tool.

Power: 9 volt DC, 150 milliamp uses 9 volt wall plug adaptor.
5 -6 hours operation from internal 6 cell nickel cadmium battery pack, must be recharged when low battery is displayed.
Size: 5.3" high x 3.9" wide x 1.4" deep.
Weight: 15 oz.
Range: 20 Hertz to 3 GHz
Input A: 50 ohm - 1 MHz - 250 MHz on 200 MHz range
             50 ohm 200 MHz to 700 MHz on 700 MHz range
Input B: 50 ohm 700 MHz to 3 GHz